sudo smartctl --all /dev/sda smartctl 6.5 2016-01-24 r4214 [x86_64-linux-4.4.0-31-generic] (local build) Copyright (C) 2002-16, Bruce Allen, Christian Franke, www.smartmontools.org === START OF INFORMATION SECTION === Model Family: Seagate Barracuda ES.2 Device Model: ST31000340NS Serial Number: 9QJ5MQB5 LU WWN Device Id: 5 000c50 019b24e4a Firmware Version: 300J User Capacity: 1,000,204,886,016 bytes [1.00 TB] Sector Size: 512 bytes logical/physical Rotation Rate: 7200 rpm Device is: In smartctl database [for details use: -P show] ATA Version is: ATA8-ACS T13/1699-D revision 4 SATA Version is: SATA 2.6, 3.0 Gb/s Local Time is: Tue Oct 25 06:44:48 2016 UTC ==> WARNING: There are known problems with these drives, see the following Seagate web pages: http://knowledge.seagate.com/articles/en_US/FAQ/207931en http://knowledge.seagate.com/articles/en_US/FAQ/207963en SMART support is: Available - device has SMART capability. SMART support is: Enabled === START OF READ SMART DATA SECTION === SMART overall-health self-assessment test result: FAILED! Drive failure expected in less than 24 hours. SAVE ALL DATA. See vendor-specific Attribute list for failed Attributes. General SMART Values: Offline data collection status: (0x82) Offline data collection activity was completed without error. Auto Offline Data Collection: Enabled. Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Total time to complete Offline data collection: ( 634) seconds. Offline data collection capabilities: (0x7b) SMART execute Offline immediate. Auto Offline data collection on/off support. Suspend Offline collection upon new command. Offline surface scan supported. Self-test supported. Conveyance Self-test supported. Selective Self-test supported. SMART capabilities: (0x0003) Saves SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. General Purpose Logging supported. Short self-test routine recommended polling time: ( 1) minutes. Extended self-test routine recommended polling time: ( 227) minutes. Conveyance self-test routine recommended polling time: ( 2) minutes. SCT capabilities: (0x103d) SCT Status supported. SCT Error Recovery Control supported. SCT Feature Control supported. SCT Data Table supported. SMART Attributes Data Structure revision number: 10 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE 1 Raw_Read_Error_Rate 0x000f 049 047 044 Pre-fail Always - 107760678 3 Spin_Up_Time 0x0003 099 087 000 Pre-fail Always - 0 4 Start_Stop_Count 0x0032 097 097 020 Old_age Always - 3663 5 Reallocated_Sector_Ct 0x0033 001 001 036 Pre-fail Always FAILING_NOW 2071 7 Seek_Error_Rate 0x000f 074 060 030 Pre-fail Always - 268105588902 9 Power_On_Hours 0x0032 064 064 000 Old_age Always - 31551 10 Spin_Retry_Count 0x0013 100 100 097 Pre-fail Always - 0 12 Power_Cycle_Count 0x0032 097 037 020 Old_age Always - 3177 184 End-to-End_Error 0x0032 100 100 099 Old_age Always - 0 187 Reported_Uncorrect 0x0032 001 001 000 Old_age Always - 1185 188 Command_Timeout 0x0032 100 098 000 Old_age Always - 30065295369 189 High_Fly_Writes 0x003a 059 059 000 Old_age Always - 41 190 Airflow_Temperature_Cel 0x0022 048 044 045 Old_age Always In_the_past 52 (Min/Max 52/53 #6) 194 Temperature_Celsius 0x0022 052 056 000 Old_age Always - 52 (0 18 0 0 0) 195 Hardware_ECC_Recovered 0x001a 038 034 000 Old_age Always - 107760678 197 Current_Pending_Sector 0x0012 100 100 000 Old_age Always - 48 198 Offline_Uncorrectable 0x0010 100 100 000 Old_age Offline - 48 199 UDMA_CRC_Error_Count 0x003e 200 200 000 Old_age Always - 10 SMART Error Log Version: 1 ATA Error Count: 217 (device log contains only the most recent five errors) CR = Command Register [HEX] FR = Features Register [HEX] SC = Sector Count Register [HEX] SN = Sector Number Register [HEX] CL = Cylinder Low Register [HEX] CH = Cylinder High Register [HEX] DH = Device/Head Register [HEX] DC = Device Command Register [HEX] ER = Error register [HEX] ST = Status register [HEX] Powered_Up_Time is measured from power on, and printed as DDd+hh:mm:SS.sss where DD=days, hh=hours, mm=minutes, SS=sec, and sss=millisec. It "wraps" after 49.710 days. Error 217 occurred at disk power-on lifetime: 31550 hours (1314 days + 14 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 04 71 04 9d 00 32 e0 Device Fault; Error: ABRT Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- a1 00 00 00 00 00 a0 00 00:02:09.931 IDENTIFY PACKET DEVICE ec 00 00 00 00 00 a0 00 00:02:09.931 IDENTIFY DEVICE 00 00 00 00 00 00 00 ff 00:02:09.619 NOP [Abort queued commands] a1 00 00 00 00 00 a0 00 00:02:04.611 IDENTIFY PACKET DEVICE ec 00 00 00 00 00 a0 00 00:02:04.611 IDENTIFY DEVICE Error 216 occurred at disk power-on lifetime: 31550 hours (1314 days + 14 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 04 71 04 9d 00 32 e0 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- ec 00 00 00 00 00 a0 00 00:02:09.931 IDENTIFY DEVICE 00 00 00 00 00 00 00 ff 00:02:09.619 NOP [Abort queued commands] a1 00 00 00 00 00 a0 00 00:02:04.611 IDENTIFY PACKET DEVICE ec 00 00 00 00 00 a0 00 00:02:04.611 IDENTIFY DEVICE 00 00 00 00 00 00 00 ff 00:02:04.299 NOP [Abort queued commands] Error 215 occurred at disk power-on lifetime: 31550 hours (1314 days + 14 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 04 71 04 9d 00 32 e0 Device Fault; Error: ABRT Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- a1 00 00 00 00 00 a0 00 00:02:04.611 IDENTIFY PACKET DEVICE ec 00 00 00 00 00 a0 00 00:02:04.611 IDENTIFY DEVICE 00 00 00 00 00 00 00 ff 00:02:04.299 NOP [Abort queued commands] a1 00 00 00 00 00 a0 00 00:02:04.277 IDENTIFY PACKET DEVICE ec 00 00 00 00 00 a0 00 00:02:04.262 IDENTIFY DEVICE Error 214 occurred at disk power-on lifetime: 31550 hours (1314 days + 14 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 04 71 04 9d 00 32 e0 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- ec 00 00 00 00 00 a0 00 00:02:04.611 IDENTIFY DEVICE 00 00 00 00 00 00 00 ff 00:02:04.299 NOP [Abort queued commands] a1 00 00 00 00 00 a0 00 00:02:04.277 IDENTIFY PACKET DEVICE ec 00 00 00 00 00 a0 00 00:02:04.262 IDENTIFY DEVICE 2f 00 01 10 00 00 a0 00 00:02:04.239 READ LOG EXT Error 213 occurred at disk power-on lifetime: 31550 hours (1314 days + 14 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 04 71 04 9d 00 32 e0 Device Fault; Error: ABRT Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- a1 00 00 00 00 00 a0 00 00:02:04.277 IDENTIFY PACKET DEVICE ec 00 00 00 00 00 a0 00 00:02:04.262 IDENTIFY DEVICE 2f 00 01 10 00 00 a0 00 00:02:04.239 READ LOG EXT 47 00 01 10 00 00 a0 00 00:02:04.235 READ LOG DMA EXT 60 00 00 ff ff ff 4f 00 00:01:56.721 READ FPDMA QUEUED SMART Self-test log structure revision number 1 Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error # 1 Short offline Completed: unknown failure 90% 31548 0 # 2 Short captive Completed without error 00% 100 - # 3 Short captive Completed without error 00% 96 - # 4 Short captive Completed without error 00% 78 - # 5 Short captive Completed without error 00% 53 - # 6 Short captive Completed without error 00% 40 - # 7 Short captive Completed without error 00% 33 - # 8 Short captive Completed without error 00% 0 - # 9 Short captive Completed without error 00% 0 - SMART Selective self-test log data structure revision number 1 SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS 1 0 0 Not_testing 2 0 0 Not_testing 3 0 0 Not_testing 4 0 0 Not_testing 5 0 0 Not_testing Selective self-test flags (0x0): After scanning selected spans, do NOT read-scan remainder of disk. If Selective self-test is pending on power-up, resume after 0 minute delay.